Point And Shoot Camera Buit-in Flash Bounce Card Reflector

Description

Another one of my unique 3D printed design.  If you're a photographer on the move, and only packed your point and shoot with you, then toss one of these into the bag because it's small and handy, and bounce your built-in flash against the ceiling for a nice soft light look.
It takes only seconds to install, and folds neatly flat instead of taking up lots of space. No batteries, weighs less than two ounces.
No more horrible light and harsh shadow if you're in a reasonable size room. Your built in flash doesn't have a lot of power, so you may have to raise your ISO a little to get that extra reach if your camera is capable.
Check out the sample photos, first one is with the bounce, second one is without.  They are all taken seconds apart in same light condition. This was done with my Olympus Tough TG-4 shown (Camera not included!!!!!)
I'm not sure if this will fit your camera, it's very adjustable, but just in case:  I will take returns per ebay return policy.
These items are 3D printed, and I hope you know that they are not like injection molded plastic...They are strong and durable, but some may think that the finish is rather...rough. So please ask questions because I don't want to mislead your expectation. Thanks so much!